Homing ASDA A2

Cevapla
Kullanıcı avatarı
khodakovdavid
Mesajlar: 1
Kayıt: 07 Mar 2021, 10:38
İletişim:
Durum: Çevrimdışı

Homing ASDA A2

Mesaj gönderen khodakovdavid »

Colleagues, we need help.
AS218PX - CAN-open - ASDA-A2
Has anyone done homing WITHOUT looking for a Z-mark? (homing mode Р5-04 = 0х0022)
Can't win ...
I need to - run over the homing sensor. And only that. But for some reason, the ZRNC unit, after leaving the sensor, makes an incomprehensible jerk in the forward (initial) direction.
And if you do as in picture 1, then it does not reset the coordinates.
And if you do as in picture 2,3, then there is a jerk as I wrote at the beginning
I apologize if it is written illiterately, I am from Ukrain and write through an interpreter
Your thoughts. Thank.
Bu mesaja eklenen dosyaları görüntülemek için gerekli izinlere sahip değilsiniz.
Kullanıcı avatarı
Uğur
Mesaj Panosu Yöneticisi
Mesajlar: 8874
Kayıt: 06 Mar 2018, 10:37
Konum: İstanbul
İletişim:
Durum: Çevrimdışı

Re: Homing ASDA A2

Mesaj gönderen Uğur »

You can see how to operate homing when parameter is 22. Servo motor goes to ORGP sensor and than stop when find it. And go back with low speed of home. It will be stop when not see ORGP.
Bu mesaja eklenen dosyaları görüntülemek için gerekli izinlere sahip değilsiniz.
Uğur Birdal - Technical Support Team Manager - DELTA Electronics Turkiye

Bildirimler İçin Whatsapp Kanalımıza Katılın
Whatsapp Kanal

https://www.linkedin.com/in/ugurbirdal
Cevapla

“Servo Forum” sayfasına dön