Delta B3 Servo help

[shebi87]

Dear All,

can i use a single PLC output Y0.0 and Y0.1 (AS PLC) to feed to 2 servo drives B3?

waiting for reply

Thanks

[İslam]

Hi,

You want to drive 2 different B3 servos with Y0.0 OR Y0.1 outputs, is that correct? If so, you can drive 2 servos with a single output.

[shebi87]

Yes, I am working on a blister packing machine in which i need servo synchronisation so for that purpose i want to send drive pulsed to 2 B3 drives with Y0.0 and Y0.1

[shebi87]

one more question regarding this,
i am running 2 servos with single output y0.0 and y0.1. can i also adjust the speed of each servo individually?

[İslam]

Yes

[shebi87]

How?
I am sending pulses to 2 servos (B3) via y0.0 and y0.1
and adjusted gear ratio for synchronisation

[İslam]

You don't just send pulses from the controller. You also send the frequency of the pulse. What is the command you use?

[shebi87]

I want to run the servo continuously so I have set position 0 and pulse frequency according to requirement
i am using DPLSY instruction

[İslam]

You can also use the DPLSV command. This command produces infinite pulses. You can send the frequency (speed) of the pulse on the command.