Delta Türkiye - Online Teknik Destek

Dear All,

can i use a single PLC output Y0.0 and Y0.1 (AS PLC) to feed to 2 servo drives B3?

waiting for reply

Thanks

Hi,

You want to drive 2 different B3 servos with Y0.0 OR Y0.1 outputs, is that correct? If so, you can drive 2 servos with a single output.

Yes, I am working on a blister packing machine in which i need servo synchronisation so for that purpose i want to send drive pulsed to 2 B3 drives with Y0.0 and Y0.1

one more question regarding this,
i am running 2 servos with single output y0.0 and y0.1. can i also adjust the speed of each servo individually?

Yes

How?
I am sending pulses to 2 servos (B3) via y0.0 and y0.1
and adjusted gear ratio for synchronisation

You don't just send pulses from the controller. You also send the frequency of the pulse. What is the command you use?

I want to run the servo continuously so I have set position 0 and pulse frequency according to requirement
i am using DPLSY instruction

You can also use the DPLSV command. This command produces infinite pulses. You can send the frequency (speed) of the pulse on the command.