VFD EL W ile 380V Motor Pıd kontrol

[kagan565]

SX2 PLC'miz var Sürücümüz var pıd ile motor kontrol etmek istiyoruz (motor, sıcaklığa göre hızlanıp yavaşlayacak). Kontrol modlarından ne seçmeliyiz nasıl ayarlar olmalı yardımcı olursanız seviniriz. Genel olarak diğer pıd parametrelerini de paylaşabilirseniz seviniriz. İyi günler .
S3+4: Control mode
0: Automatic control
1: Forward control (E = SV - PV).
2: Reverse control (E = PV - SV).
3: Auto-tuning of parameter exclusively for the temperature
control. The device will automatically become K4 when
the auto-tuning is completed and KP, KI and KD is set with
appropriate value (not avaliable in the 32-bit instruction).
4: Exclusively for the adjusted temperature control (not
avaliable in the 32-bit instruction).
5: Automatic mode with MV upper/lower bound control.
When MV reaches upper/lower bound, the accumulation
of integral value stops.
7: Manual control 1: User set an MV. The accumulated
integral value increases according to the error. It is
suggested that the control mode should be used in a
control environment which change more slowly.
DVP-ES2/DVP-EX2/DVP-SS2/DVP-SA2/DVP-SX2
series PLCs whose version is 2.00 (or above), and
DVP-SE series PLCs whose version is 1.00 (or above)
are supported.
8: Manual control 2: User set an MV. The accumulated
integral value will stop increasing. When the control
mode becomes the automatic mode (the control mode
K5 is used), the instruction PID outputs an appropriate
accumulated integral value according to the last MV.
DVP-ES2/DVP-EX2/DVP-SS2/DVP-SA2/DVP-SX2
series PLCs whose version is 2.00 (or above), and
DVP-SE series PLCs whose version is 1.00 (or above)
are supported.
10: TI / TD mode: The control changes the integra gain and
the differential gain into integral time constant and
differential time constant.

[Uğur]

79-DVP PLC Auto Tuning ve PID Fonksiyonu